Random good picture Not show

61) Silicon rectifier, general purpose, high voltage, fast recovery (surface mount). Max recurrent peak reverse voltage 400V. Max average forward rectified current 0.5A.

62) A new type of infrared intelligent DC high voltage generator was introduced.

63) The 4 MV electrostatic accelerator consists of four parts, a high voltage system, an ion source and beam transmission system, a control system and a gas system.

64) In order to decrease the asymmetry of current and voltage of the power system[sentencedict .com], the high voltage transmission lines should be transposed in principle.

65) The system consists of two modules: gating pulse module and high voltage modulation module.

66) Several pulsed parts made up a negative bias pulsed power, whose frequency and duty cycle is regulated directly at the side of high voltage.

67) Principle of high voltage power supply based on PWM chip TL494 is introduced in this paper. The adjustment of the voltage is performed by digital potentiometer controlled by MCU.

68) A much smaller power loss occurs in the cable when energy is transmitted at high voltage.

69) The Keypad terminal or optional PC provides a display of the site and all high voltage readings for each zone around the fence line.

70) The plasma source ion implantation device consists of pulsed negative high voltage power, hot cathode arc discharge system, vacuum chamber and target stage[sentencedict.com], vacuum system and monitor system.

71) This paper presents a high voltage generator for the defibrillator.

72) The chopped mode feedback is a scheme for solving the motor's speed regulation by means of controlling the high voltage with low voltage.

73) The microwave electronic power supply requires high voltage and high power, so the two-section conversion structure, the front and the back, is adopted in the designing scheme of the power supply.

74) Bachelor degree of Mechanical, civil or Electrical. Experience of high voltage power supply system is preferred.

75) A device for protecting a semiconductor device from electrostatic discharge may include a high voltage first conductivity type well formed in a semiconductor substrate.

76) Middle and high voltage transformer coil frameworks in the electric appliances of microwave ovens, neon lamps, etc. all can adopt the utility model.

77) In this paper an example is given, the field of neighboring corner region of the high voltage winding in a transformer had been calculated. The favorable influence o...

78) This paper presents a novel kind of fiber optically powered instrument for high voltage line current.

79) When the wave wells up the regulation that the voltage is greater than the gas in charge of, gas in charge of discharge earth connection too high voltage, Protect the apparatus systematically.

80) According to the thickness of the SOI film, high voltage IC based on SOI material (SOI-HVIC) can be divided into thin-film and thick-film.

81) This paper presents an overview of related Japanese product standard, testing method, requirement for material, design theory and technological process for very high voltage film capacitor.

82) The design method of the high voltage and the fast response time pulse transformer used in the condition of low load impedance was introduced.

83) As the reactor is a equipment of high voltage alternating magnetic field, for the sake of safety, people can"t close to it when it is operating."

84) In traditional electric fence systems, the high voltage wires are interleaved with earth wires up to the height of the fence line, which means that every second wire provides no deterrent.

85) A new leak current model of high voltage DC leak detection is developed.

86) KEMET introduces the T521 Series High Voltage Polymer Tantalum Capacitor, the first 35 volt rated polymer tantalum chip capacitor.

87) A second stack region may have a second conductivity type drift region, and a second conductivity type impurity region stacked in succession in the high voltage first conductivity type well.

88) Two Critical concepts involved in direct current ice-melting technique of high voltage over head line, the least ice-melting current and the max allowed current was presented.

89) A high voltage power supply circuit featuring mini-volume, light weight and good performances is described in this paper.

90) A high voltage live displaying and locking device was developed to indicate whether the primary equipment is live or not and to prevent misoperation of high voltage circuit breakers.